VIVO Dual LCD LED Monitor Desk Mount Stand There is a reason this has a #1 Best Seller flag on it. Its extremely good for what you are paying for it. I wanted to get my desk cleared off and was seriously thinking about getting a second monitor to use. I came across this on amazon and decided to give it a try. I had read through a lot of the reviews. Most of them were good to excellent and some were not. I was hoping my experience was going to be better than some of theirs. The first thing I noticed when i received this mount was just how heavy the boxes containing it were. I was expecting some heft. I mean this has to support two monitor up to 27 inches each, but it was heavier than I was anticipating. I found most of the parts inside wrapped in plastic and in good condition. I followed the instructions and did not have any problem assembling this item. You attach the clamp to the post first, then mount that part on your desk where you want it. The clamp seems plenty strong enough to hold it. Just make sure your desk is strong enough. I have a all steel tanker desk so it was not problem for me. If you have a thin top you might want to think about placing a piece of wood under the desk in the clamp to help distribute the weight of the monitors. I would not mount this too glass at all. That might be a common sense thing, but just a warning. After mounting the clamp/pole to the desk, you will want to place the vesa mounts on the monitors. This kit came with handy thumbscrews just for this, and they worked great. I did not need any special adapters for my monitors, both were 100x100 vesa mount compatible and the plates fit it perfectly. The mounts attached to the monitors will slide onto the plate on the post. This also worked great for me. No issue. Once you get the monitors on the arms, there is a tiny screw cap for the back to make sure the monitors stay on the arms. I will not be rotating my so this isn't an issue, but I put them there anyways. The post does have height adjustment, do not do this with the monitors on the arms. Take them off then adjust the post. Put them back on and repeat as necessary until where you want them. I saw some reviewers talking about how they could not keep the monitors level. I am going to guess that they have faulty kits. I have no problem here. The joint that allows the monitor to rotate seem nice and tight, but also easily movable if I wanted them too. The tilt of the monitor can be adjust up or down and then tighten with the included allen wrench. I am sporting a 24 inch monitor on the left and a 27 inch monitor on the right with absolutely no physical problems. The multiple points of articulation in the arms made moving my monitors around a breeze. They stay where I put them too. There are hooks for cable management which do help a lot in keeping a clean look. I could only use some of it because of a short power cord and dvi cable. You can see from the photos that the post is leaning forward ever so slightly. It does not seem to be going any further and it is extremely stable. One thing I can highly recommend is an Aukey LED gooseneck clamp light. It will clamp right to one of the arms and reaches over the monitors. It provides good light and runs off USB power. It looks like it belongs with the mount. I could not be happier with how that turned out. I am completely satisfied with this mount. I love it. I recommend it to anybody who needs to get their monitors off the desk and more at eye level. AUKEY LED Desk Lamp, Clip-on Table Lamp with Flexible Neck, USB Powered with 2 Brightness Adjustment for reading